Mark (TheCraftsmansPath.com) on December 2nd, 2009

With the band sawing of the rear legs completed and the head rest holes drilled I set out to shape the rear legs and to band saw and shape the front legs. Some of the shaping of the legs could be done with a round-over bit in a router table however, because of the irregular […]

Continue reading about Sculpted Rocking Chair: Front Legs and Initial Leg Shaping

Mark (TheCraftsmansPath.com) on October 28th, 2009

Well, I have finally gotten back to work on the Sculpted Rocking Chair – yes, I know it’s been a while! When I last left the project, I had completed sculpting the seat.  With that task completed my attention turned back to more processing on the rear legs. The rear legs needed to have a […]

Continue reading about Sculpted Rocking Chair: More Rear Leg Work

Mark (TheCraftsmansPath.com) on May 17th, 2009

Well I knew it had to come to an end some time.  Friday was the final day of the Hut Board Class at the Marc Adams School of Woodworking and to boot it was a shortened day due to shop clean-up and packing at the end of the day. The morning was filled with  some […]

Continue reading about Hunt Board Class: Day 5

Mark (TheCraftsmansPath.com) on May 14th, 2009

Well  I am still at work here in Franklin, Indiana at the Marc Adams School of Woodworking.  The Hunt Board class has certainly been a marathon of woodworking…sometimes bordering on speed-woodworking. I did not update you with a post yesterday because I was attending the traditional school dinner that is put on during each week […]

Continue reading about Hunt Board Class: Days 3 and 4

Mark (TheCraftsmansPath.com) on May 12th, 2009

Day 2 of the Hunt Board class was fairly productive.   This will be a fairly short post because I still have some sharpening to do to prepare for tomorrow and I am dead tired! In the pictures you can see the notes on the blackboard with yesterdays mortising assignment.  Notice the that Einstein’s Theory was […]

Continue reading about Hunt Board Class: Day 2