Mark (TheCraftsmansPath.com) on January 21st, 2009

If you’ve been following along with this project, you know that I completed the inlay and the glue-up in my last post. So, it was on to sanding and finishing tasks. I’m not sure how I liked working with the Hard Maple on this project. Even with careful reading of the grain of each board, […]

Continue reading about Modern Shaker Table: Completion

Mark (TheCraftsmansPath.com) on April 29th, 2008

Well, after a wait for the finish to cure and my being out of town, the Queen Anne Side Table is finally ready for its unveiling. When I last posted about this table, the construction was complete and I spoke about the possible options for a finish. In the end, I went with a finish […]

Continue reading about Queen Anne Side Table: Completed finish and hardware

Mark (TheCraftsmansPath.com) on March 4th, 2008

With the bulk of the construction on the table complete, it was time to move on to the detailing tasks and finish work. I spent a considerable amount of time scraping and sanding all of the parts of the table. There were areas on the legs where the knees transition into the posts that needed […]

Continue reading about Queen Anne Side Table: Contemplating the finish